Lambda, will this fit?

Rich H · Post by **Rich H** » Sun Aug 20, 2006 11:01 am

Morning all, my 4-2-1 arrives tomorrow with a bit of luck. While I will attempt to remove the original Lambda sensor I recognise that this is probably a waste of time.

The liz parts ones are over £70 but will this fit? it's £18

http://tinyurl.com/p27hx

Ta
Rich

roadboy · Post by **roadboy** » Sun Aug 20, 2006 4:39 pm

Don't normally have any trouble getting old ones out Richard. If its being stubborn, cut the wires and use a ring key.

Dan@JPS

Rich H · Post by **Rich H** » Sun Aug 20, 2006 4:41 pm

Cheers Dan, I'll have a crack tomorrow and if necessary get medieval on it....

Rich

robin · Post by **robin** » Sun Aug 20, 2006 6:13 pm

Sounds like the same part - if you do fit it be sure to mate the wires well - the heater wires carry a fair old current and obviously it all gets pretty hot anyway given where it's fitted.

Cheers,
Robin

Victor Meldrew · Post by **Victor Meldrew** » Sun Aug 20, 2006 8:33 pm

RICHARDHUMBLE wrote:Cheers Dan, I'll have a crack tomorrow and if necessary get medieval on it....

Rich

electric drive impact available if required.... just give me an excuse for a run if its dry..

Rich H · Post by **Rich H** » Sun Aug 20, 2006 9:05 pm

Cheers John, May have to resort to special measures...

If its raining (Or the boss won't let you out!) I'll use the air driven one at work I found the other day.

Titanium S1 111S (gla) · Post by **Titanium S1 111S (gla)** » Tue Aug 22, 2006 10:55 am

Richard,

Did you find out whether this one fits?

Graham

Rich H · Post by **Rich H** » Tue Aug 22, 2006 5:04 pm

Not as yet I'm about to wrap the 4-2-1 then fit may be tomorrow...