Page 1 of 1
How to get the front badge on?
Posted: Fri Aug 19, 2005 5:30 pm
by jj
I want to re-attach my clam badge. It is the enamel one with the two prongs that gets screwed with the wee rubber things onto the clam.
Can this be done with the clam on? I had a look there and cant see any way of getting in to screw it from behind (snigger).
Any tips?
Posted: Sun Aug 21, 2005 6:45 pm
by ninja
no idea!
i've got the reverse problem. my badge is damaged (stone chip) and i want to replace it! so i'll be watching to see the response to this cos i can't find an easy way of getting the bugger off!
ninja
Posted: Sun Aug 21, 2005 7:48 pm
by jj
I thought S2s were stickers and S1s were screwed?
I have put it on at the moment by bending the two pins in slightly so its held in the clam by the pins and used some double sided number plate tape.
Its solid but not on properly if you know what I mean, but if its a clam off job to screw it on then screw that....
Posted: Sun Aug 21, 2005 10:36 pm
by simon
S1 = clam off job
S2 = meant to be clam on but MMC couldn't get mine off to replace it so they said it might actually be a clam off job
