Page 1 of 1
Lotus friendly garage in Aberdeen
Posted: Mon Mar 22, 2010 5:56 pm
by Davie
I have a few small faults with my exige that need to get fixed; central locking and heater fan not working. I've had a look on SELOC and these seem to be fairly common problems but looking for a garage in Aberdeen that is familiar and trust worthy with Lotus as don't fancy the cost and time of going to MMC. Any recommendations??
Re: Lotus friendly garage in Aberdeen
Posted: Mon Mar 22, 2010 6:12 pm
by andyc
I have used JD Motor engineers in Insch before....good guys.
Also, Ricky Gauld near Huntly....good guy.
Re: Lotus friendly garage in Aberdeen
Posted: Mon Mar 22, 2010 6:15 pm
by vx220
Jim at Fyvie Garage are good and used to working on Lotus!
Re: Lotus friendly garage in Aberdeen
Posted: Mon Mar 22, 2010 6:34 pm
by Mr Momo
Davie wrote:I have a few small faults with my exige that need to get fixed; central locking and heater fan not working. I've had a look on SELOC and these seem to be fairly common problems but looking for a garage in Aberdeen that is familiar and trust worthy with Lotus as don't fancy the cost and time of going to MMC. Any recommendations??
Is it the heater or the heater fan (just that the causes/solutions are different) ?
Re: Lotus friendly garage in Aberdeen
Posted: Mon Mar 22, 2010 6:42 pm
by Davie
think it's the resistor pack asit was working on two the three speeds and then packed in totally as car was sitting for several months while overseas
Re: Lotus friendly garage in Aberdeen
Posted: Mon Mar 22, 2010 6:45 pm
by Mr Momo
Clam off job then

Re: Lotus friendly garage in Aberdeen
Posted: Mon Mar 22, 2010 6:56 pm
by Davie
well not sure as on seloc it says it can be done without taking the clam off ?
Re: Lotus friendly garage in Aberdeen
Posted: Mon Mar 22, 2010 9:04 pm
by renmure
Ali at SLS fixed mine (well, replaced it with a new one). Was a clam off jobbie.
He came up to mine to do it tho, and I know he goes up to Abz.
Re: Lotus friendly garage in Aberdeen
Posted: Mon Mar 22, 2010 9:15 pm
by vx220
I think on the VX you didnt need to remove the clam to sort, but might be different on the Exige?