Page 1 of 3
Front Number Plate - What size?
Posted: Sun May 14, 2006 10:22 pm
by Stewart
After crunching my front plate for a second time in a fortnight, it's time for a small one.
I was looking at
http://www.fancyplates.com and see they do a 3/4 size one which measures 390mm X 84mm. I measured my plinth and this seems to a wee bit too wee.
Can anyone advise if the have a 3/4 size one on their S1 and is it ok?
Cheers
Stewart
Posted: Sun May 14, 2006 10:27 pm
by Rich H
Can you not get a legal plate that is the same size as the plinth? Right size letters and borders but smaller plate overall. Its only a matter of time before mine finally falls off....
Rich
Posted: Sun May 14, 2006 10:29 pm
by simon
Get a legal one like mine then you won't get a £30 fine when you get pulled over for a 3/4 size one.
Posted: Sun May 14, 2006 10:31 pm
by Stewart
Posted: Sun May 14, 2006 10:33 pm
by simon
Bad choice of pic that one
Posted: Sun May 14, 2006 10:34 pm
by simon
Try this one:
Posted: Sun May 14, 2006 10:36 pm
by simon
Saying that, mine is only small cos it's a private plate with 5 characters.
Dunno if yours will go much smaller than it already is.
I also think 3/4 size ones look a bit chav/ned.
Posted: Sun May 14, 2006 10:40 pm
by Stewart
simon wrote:
Bad choice of pic that one
Sorry, must of caught you on an off day ... oh no ... wait a minute ...
you really must get better velcro
Posted: Sun May 14, 2006 10:43 pm
by simon
Posted: Sun May 14, 2006 10:46 pm
by Rich H
It just fell off on that speed bump officer, look I have it here.....
Posted: Mon May 15, 2006 9:18 am
by Sanjøy
Theres that dream car to the left of it again, must be worth a fortune.
Posted: Mon May 15, 2006 10:27 am
by Tom
Sanjoy wrote:Theres that dream car to the left of it again, must be worth a fortune.
I heard it outran an exige.. Is that true??
Posted: Mon May 15, 2006 1:50 pm
by Baggy
3/4
haven't been stopped yet (2 years).......runs off to touch wood
I think you get away with it cos the Frontal area is about 3/4 of a normal car so it doesn't look too out of place........runs off to touch wood again for good measure.
Posted: Mon May 15, 2006 1:57 pm
by jj
I have motorbike sized plates front and rear and have done so on 3 cars now without problems. Like baggy said, it looks in proportion. Have been followed and stopped by the cops and nothing has been said.
The pair were under 20quid from the numberplate shop in Glasgow, which is not bad.
Posted: Mon May 15, 2006 1:57 pm
by GregR
Sanjoy wrote:Theres that dream car to the left of it again, must be worth a fortune.
is this the one Sanj?
