Quick question for the engine builders....

[steve_weegie]

Gents,

Is the liner to block sealant i need just blue hylomar? Part number i have is GGC 102 but needless to say my local rover dealer has never heard of it!

Cheers,

Steve

[tenkfeet]

I have some blue Hylomar in the garage , aero grade . Its been in there for years , dont think it goes off .

Don't know how much you will need , its about half a tubes worth .

[Rich H]

It goes all gloopy and refuses to spread quite quickly, get some fresh

[philthy]

At least it won't catch fire on the Liz...

Make it out of Phynol board / Paxolin, much tougher than plywood

wrong thread...

[Rich H]

Bugger, too slow...

[robin]

Yes it does seem as though GGC 102 is hylomar blue - don't use that for the sump, cam or bearing ladders though!!!

Cheers,
Robin

[woody]

Did I give you a tube of Dow Coring 736 (red silicone RTV) for the sump? If not, got some here.

[Rich H]

Yes it does seem as though GGC 102 is hylomar blue - don't use that for the sump, cam or bearing ladders though!!!

Cheers,
Robin

Why? That's what I used IIRC....

[r10crw]

The liners are floating so need the non drying hylomar for movment but will get displaced from fixed fits and clog internals, at least thats what i think, rest assured Robin will be allong shortly. Either way Im sure you shouldnt use for cam, sump or bearing ladders, think someone did it on a rebuild blog once and had to remove clean and refit?

[steve_weegie]

Cheers guys.

I'll acquire some blue hylomar goo for the liners and will use my red goo for the cam and bearing ladders (loctite anaerobic stuff)

And woody, yes you did indeed give me some other red goo for the sump with the molykote for the crank

Anyone know where i can get hylomar from? Machargs were a bit clueless when i gave them the part number...

[Rich H]

Hellfrauds