The place to "speak geek"
-
Edin430
- Posts: 2952
- Joined: Mon May 21, 2007 2:11 pm
- Location: Edinburgh..
Post
by Edin430 » Sat Jun 21, 2008 3:35 pm
I know the standard tyre for the front of an Exige is 195/50/16 but would it matter much if I put on 195/
45/16's on?
Also, what are the digits after? The tyres I am looking at (to match the rears) have 84w after them...
Thanks
-
meatball
- Posts: 5043
- Joined: Sun Dec 31, 2006 9:50 pm
- Location: LOST!
Post
by meatball » Sat Jun 21, 2008 3:47 pm
It'll be a lower profile tyre.....the digits after are the speed rating of the tyre.
-
Edin430
- Posts: 2952
- Joined: Mon May 21, 2007 2:11 pm
- Location: Edinburgh..
Post
by Edin430 » Sat Jun 21, 2008 3:56 pm
Lower profile won't matter much I guess when its only 45 not 50...
Does the speed rating matter then? 84w ok for normal road driving?
EDIT - Just checked and I know the W is okay now.. And the 84 is in line with the load of the vehicle. So guessing it should be okay

-
philthy
- Posts: 2561
- Joined: Fri Aug 04, 2006 1:01 pm
- Location: Glasvegas
Post
by philthy » Sat Jun 21, 2008 5:30 pm
It wont be the same - I had some 45 profile tyres on the exige instead of the 50s and it scraped a lot more at the front over speedbumps etc than on the 50s. It also understeered more.
S1 Elige Audi 1.8T
S1 Elise Honda K20
VW T6.1 family bus
-
Edin430
- Posts: 2952
- Joined: Mon May 21, 2007 2:11 pm
- Location: Edinburgh..
Post
by Edin430 » Sun Jun 22, 2008 10:55 am
hmmmmmmm that changes it slightly.... 10mm is quite a lot considering how low the car already is!
Back to the drawing board

-
Victor Meldrew
- Posts: 5733
- Joined: Wed Jun 29, 2005 1:01 pm
- Location: Unable to use location services. Please turn on your wifi....
Post
by Victor Meldrew » Sun Jun 22, 2008 11:17 am
Does your Exige have ABS.....?
If so it will ca confuse the wheel speed sensors and may trigger the ABS at the wrong time or not at all....
Had a similar problem with a peugot a while back, the abs released the brakes every time I slowed below 5mph down for a junction.....
Well it moves... might as well make the most of it....
-
Edin430
- Posts: 2952
- Joined: Mon May 21, 2007 2:11 pm
- Location: Edinburgh..
Post
by Edin430 » Sun Jun 22, 2008 7:57 pm
Victor Meldrew wrote:Does your Exige have ABS.....?
If so it will ca confuse the wheel speed sensors and may trigger the ABS at the wrong time or not at all....
Had a similar problem with a peugot a while back, the abs released the brakes every time I slowed below 5mph down for a junction.....
Yup it does indeed !
Investigating different tyres at the moment. May just buy a full set of T1-Rs as originally planned to avoid any hassle
