S2 Bits

mac · Post by **mac** » Thu Jan 26, 2006 12:06 pm

Help!

I've lost most, if not all of my undertray washers. Anybody know the spec of them inner and outer diameters?

Cheers

Mac

gordon · Post by **gordon** » Thu Jan 26, 2006 12:08 pm

Jeess. some folk will do anything to save some weight

Post by **Shug** » Thu Jan 26, 2006 12:14 pm

Lemme guess, you dropped them in the "Pit of Doom"...

If nobody's posted by tonight, I'll get a ruler out when I get in.

mac · Post by **mac** » Thu Jan 26, 2006 12:25 pm

I think the car might have ate them - don't recall dropping them.

And it's now know as the "watery pit of doom" - think some tanking is required

Mac

Edited: For Shug's sake

Post by **Shug** » Thu Jan 26, 2006 12:28 pm

tank tape?

fish tank?

sherman tank?

(picky mood today faction)

alicrozier · Post by **alicrozier** » Thu Jan 26, 2006 2:02 pm

Could try these...

http://www.nord-lock.com

They work and I've got Jim using them on his exhausts.

mac · Post by **mac** » Thu Jan 26, 2006 2:12 pm

In all honesty I've just lost them as time goes by and have picked up whatever has been lying around, probably getting smaller and smaller in size until now when it rattles as though it's not been done up properly. I've got a place where I can buy them from, so that's not a problem and I know the bolt size is 8mm - it's just the washer size I'm struggling for.

Cheers

Mac

Rich H · Post by **Rich H** » Mon Jan 30, 2006 12:27 am

I just went into my friendly B&Q and got 8mm repair washers.

They are big penny washers, mild steel & galvanised. Just keep an eye on 'em. I picked up a rattle after the borders run and found 3 had worked loose.

HTH
Rich