Page 1 of 1
MOT time, fingers crossed... Passed!
Posted: Fri Aug 10, 2007 12:41 pm
by Rich H
Well my car is repaired and has been sent for its MOT.
What is the minimum tread allowance for MOT? There is about 3mm on the rears, just over the wear markers (Just) will it pass like that?
Posted: Fri Aug 10, 2007 12:44 pm
by BiggestNizzy
Posted: Fri Aug 10, 2007 12:48 pm
by MacK
Wear markers are at the minimum level, so if over the wear markers then that is okay, even if on the wear markers that should be okay, because it is at the minimum allowable tread depth, and not bellow it.
Good Luck.
Posted: Fri Aug 10, 2007 1:20 pm
by Rich H
Cool cheers! It'll fail on emissions then...
Posted: Fri Aug 10, 2007 1:36 pm
by mac
wear markers not at 2mm?
Mac
Posted: Fri Aug 10, 2007 1:38 pm
by MacK
mac wrote:wear markers not at 2mm?
Mac
Could be, I've never measured them.
Posted: Fri Aug 10, 2007 2:49 pm
by Rich H
It passed! Couple of bulbs out, nothing more!
Picking it up at 6 tonight, another big
for Phoenix motorsport and Mathersons Bodyshop!
Posted: Sat Aug 11, 2007 10:45 am
by Rich H
Picked up, back to normal! No judder at 80 tuts+ and nice and clean, just got to keep it that way!
Passed its MOT but discovered this morning I had no side lights, number plate lights or rear reds (Got brake lights though)
Both side light fuses had blown
Posted: Sat Aug 11, 2007 11:31 am
by Shug
The Shed rides again
Posted: Sat Aug 11, 2007 1:39 pm
by Rich H
I have to be careful we have a SKIP on the drive at the moment, I wouldn't want to bump into it, eh Shug?...
Posted: Sat Aug 11, 2007 1:58 pm
by BiggestNizzy
RICHARDHUMBLE wrote:I have to be careful we have a SKIP on the drive at the moment, I wouldn't want to bump into it, eh Shug?...
or jump in and try and drive it off