Page 1 of 1
Plumbing/Fixings Help FALC
Posted: Tue Oct 06, 2015 2:51 pm
by shooomer
Plastic drip tray below connects to drain via hose with male fixing at the yellow circle. Plastic has fatigued and threaded plastic cylinder at yellow circle has broken off. Any ideas how I can create a watertight drain hose from just a hole in the drip tray? Ideally I want a neat fixing like a plug hole rather rather silicone/gaff tape effort (hole is around 20mm dia) TIA, Paul
Re: Plumbing/Fixings Help FALC
Posted: Tue Oct 06, 2015 3:08 pm
by r10crw
Just use a standard drain plug waste which will leave you with a standard 1'1/4 threaded fitting on the underside. It means opening the hole up to 32mm but thats no big deal??
http://www.screwfix.com/p/sprung-basin- ... tted/73414
Re: Plumbing/Fixings Help FALC
Posted: Tue Oct 06, 2015 3:09 pm
by r10crw
PS Ive got a standard one I didnt use from my bathroom last week, you can have it for nothing. If u want it send me your addy
Re: Plumbing/Fixings Help FALC
Posted: Tue Oct 06, 2015 4:30 pm
by shooomer
Found a PE black tank connector after a bit of googling
Mods, this can be deleted
Re: Plumbing/Fixings Help FALC
Posted: Tue Oct 06, 2015 6:49 pm
by BigD
Was just about to say tank connector as that's what they use to connect to water tanks etc. But you're sorted now.
