Honing a block. Where near Aberdeen?

[GregorFuk]

Perhaps this should be in the technical section but...

Does anybody know where I can get an engine block honed near or in Aberdeen?

I have a Duratec on a stand that I am contemplating building up to a medium state of tune and then swapping out with my current Duratec. I’ll need to fit new pistons & rings for this so will have to get the block appropriately honed.

Off the top of my head I can think of:

David Falconer - Aberdeen
Agra – Dundee
JEM Engines – Falkirk

Does anybody have any experience of any of the above? Am I missing any possible alternatives?


Cheers

Gregor

[philthy]

I used Agra for my 4g63 block with good results, just gave them the pistons and they machined to match (85mm to 85.5mm). Only one day turn around too.